System Configuration - Furuno FAR-1513 Installation Manual

SYSTEM CONFIGURATION

FAR-1513(-BB), FAR-1523(-BB)
FAR-1513(-BB)
XN12A-RSB-0070-086A
XN12A-RSB-0073-086A
XN13A-RSB-0070-086A
XN13A-RSB-0073-086A
TRACKBALL
CONTROL UNIT
RCU-030
DISPLAY UNIT*
12-24 VDC
MU-150HD or
100-230 VAC
1ø, 50-60 Hz
Interswitch
DC Spec.
24 VDC
100/110/115/200/
220/230 VAC
1ø, 50-60 Hz
: Standard supply
: Optional or local supply
Equipment category
Unit
Antenna Exposed to the weather
Other units Protected from the weather
*1: The gyrocompass must also have an update rate that is adequate for the ship's rate of turn.
The update rate must be better than 40 Hz (HSC) or 20 Hz (conventional vessel).
*2:This monitor have been approved by the IMO, MU-150HD and MU-152 (planned release: Early 2018)
for CAT 3. If a different monitor is to be used on IMO vessels, its effective diameter must meet the
applicable Category requirements (CAT 3: Effective diameter 180 mm or higher).
For installation, operation and viewing distance of other monitors, see their respective manuals.
For BB types, a monitor is to be prepared by the user.
*3: Characteristics of contact output for AMS (Alert Management System):
• (Load current) 250 mA
• (Polarity) Normally Open: 2 ports, Normally Close: 2 ports
*4: Standard supply with FAR-1513/FAR-1523 only.
ANTENNA UNIT
CONTROL UNIT
RCU-028
2 4
*
MU-152
SWITCHING HUB
HUB-100
PROCESSOR UNIT
Rectifier
RU-1746-B-2
RU-3424
Category
FAR-1523(-BB)
XN12A-RSB-0070-087A
XN12A-RSB-0073-087A
XN13A-RSB-0070-087A
XN13A-RSB-0073-087A
Gyrocompass *
Gyrocompass *
AIS Transponder
EPFS (GPS)
SDME (Speed log)
AMS, IEC61162 format
ECDIS
RPU-024
AMS (Contact)*
Sub Display 1
Sub Display 2
Analog RBG Monitor
1 , AD-10 format
1
, IEC61162 format
3
VDR
or
iii