How To Charge Tail Bolt - Cycle Torch Tail Bolt User Manual

Hide thumbs Also See for Tail Bolt:
Table of Contents

Advertisement

III. How to charge Tail Bolt
How to charge:
1. Remove the rubber cap at the bottom of Tail Bolt;
2. Connect the Tail Bolt to your PC or a 5V USB battery charger with the USB cable.
The lens lights up RED when the charging starts;
3. When the lens lights up GREEN - charging is complete. Remove the USB cable;
4. Full charging time: 2 ~ 4 hours
Tips and tricks:
1. When your PC is in sleep state, the Tail Bolt cannot be charged;
2. Flashing light of the power button shows that a charging error has occurred.
Remove and reinsert the USB cable, then begin the recharge process again;
3. The battery charges to about 80% after approximately 2 hours;
4. Charging and lighting times are approximate values, and will vary by
environmental and user conditions.
WARNING: The cable (or other accessories) supplied with the Cycle Torch bike
light MUST be used only to charge the Cycle Torch bike light. The Manufacture
or/and the Seller are not responsible for any damage caused by using the supplied
accessories with other devices, other than Cycle Torch bike lights.
4

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Tail Bolt and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents