Chassis And Front Cover Re-Assembly; Figure 6-17. Main Board Onto Chassis Re-Assembly - Motorola PR400 Basic Service Manual

Full Keypad Model Disassembly and Re-assembly: Disassembling and Re-assembling the Radio — General
.
Frequency &
Volume Switches
Interface Pad
Battery Contact Seal

6.4.2.6 Chassis and Front Cover Re-assembly

1. Dress and connect the speaker wires..
Note: Care should be taken when dressing the speaker and microphone wires to avoid pinching
them between the speaker magnet and shield, or between the accessory connector and
housing.
Note: Ensure that the plug orientation is correct with the exposed pins in the wire casing facing
upward and fully plugged in.
a. Connect the speaker wire assembly into the 2-pin connector on the main board and
bend the wires at the board connector so the wires are positioned toward the top of the
radio
b. Connect the microphone wire assembly into the two hole socket on the main board and
bend the wires at the board connector so the wires are positioned toward the top of the
radio
c. Slide the audio jack shroud onto accessory connector
6881096C24-A

Figure 6-17. Main Board onto Chassis Re-assembly

(Figure 6-18).
(Figure 6-18).
Audio Jack Shroud
(Replace after Plugging
in Speaker and Mic)
Main Board
Flex Cable Connector
Radio Chassis
O-Ring
(Figure 6-17).
6-13
July, 2004