Danfoss VLT HVAC Drive FC 102 Operating Instructions Manual page 15

Electrical Installation
1
9
10
L1
L2
L3
PE
1 PLC
2 Frequency converter
3 Output contactor
4 Grounding rail (PE)
5 Cable insulation (stripped)
Illustration 4.2 EMC-compliant Electrical Connection
NOTICE
EMC INTERFERENCE
Use screened cables for motor and control wiring, and separate cables for input power, motor wiring and control
wiring. Failure to isolate power, motor and control cables can result in unintended behaviour or reduced performance.
Minimum 200 mm (7.9 in) clearance between power, motor and control cables is required.
MG11AK02
Operating Instructions
2
11
8
6 Cable gland
7 Motor, 3-phase and PE
8 Mains, 3-phase and reinforced PE
9 Control wiring
10
Equalising min. 16 mm
Danfoss A/S © Rev. 06/2014 All rights reserved.
6
3
4
7
2
(0.025 in)
4 4
5
U
V
W
PE
13