Power Backup Feature - Uniden ELBT 595 Series Owner's Manual

Multi-handset phone
Hide thumbs Also See for ELBT 595 Series:
Table of Contents

Advertisement

UP744.book Page 8 Friday, November 5, 2004 4:22 PM

Power Backup Feature

note
The phone uses the power backup feature to provide power
backup for a power failure or outage.
appears if the
battery pack is not
installed in the base.
•To use power backup
feature, you need to
connect the AC adapter
to the base, and
charge the base
battery at least for 24
Install the power backup battery in the base
hours.
1) Open the battery case cover by pressing the release button on the
bottom of the base as shown.
2) Plug the battery connector (red and black wires) into the jack
inside the battery compartment. (The connector notches fit into
the grooves of the jack only one way). Match the wire colors to
the polarity label in the battery compartment, connect the battery
and listen for a click to insure connection.
3) Make sure you have a good connection by gently pulling on the
battery wires. If the connection is secure, the battery jack will
remain in place.
4) Place the battery case cover back on the base.
5) Align the tabs on the cover with the grooves on the base, and
press down the cover until it clicks into place.
w w w . u n i d e n . c o m
S e t t i n g u p t h e P h o n e [ 8 ]

Advertisement

Table of Contents
loading

This manual is also suitable for:

Elbt 595 series

Table of Contents