Power Outlet - Uniden Elite 9145 Owner's Manual

Connect the Repeater Power Cord
Use the included adapter to connect the
repeater to a regular indoor (240 V AC)

power outlet.

Placing the Repeater
Here are a few tips for placing your
repeater so that you get the clearest
signal and the maximum range:
Place the repeater just inside the base's
♦
cove rage area, that is, as far from the base as possible where you still
have good reception.
Put the repeater
♦
repeater.
If you place the repeater
♦
doesn't pull on the unit and that people walking by won't knock it off
the surface.
If possible, mount the repe
♦
Finding the Base's Coverage Area
1. Stand near the base and make a
call on a cordless handset that is
registered to that base.
2. Continue the call and carry the
handset away from the base.
Make sure you go at least 10
meters.
3. Make a note where you start to
hear noise on your call (the signal
is getting weaker). You can use
the signal strength icon on the
handset display to find the best
location: make a note where the
icon indicates the signal is getting weaker.
Elite9145om_20110115.indd 9
at least 10 m away from the base or any other
on a flat surface, make sure the power cord
ater on the wall.
Wall-mount
holes
Registration
button
No signal No signal
(all noise) (all noise)
Weak signal Weak signal
(some noise) (some noise)
Strong signal Strong signal
The noise increases as The noise increases as
the signal gets weaker the signal gets weaker
Place the repeater inside the Place the repeater inside the
strong signal range (before the strong signal range (before the
noise increases) noise increases)
Power connector
(no noise) (no noise)
During a call, carry During a call, carry
the handset from the handset from
the base the base
9
28/9/11 12:14:31 PM