Samsung ProXpress C401 series User Manual page 115

The FCC has set a general guideline of 20 cm (8 inches) separation between the device and the
body, for use of a wireless device near the body (this does not include extremities). This device
should be used more than 20 cm (8 inches) from the body when wireless devices are on. The
power output of the wireless device (or devices), which may be embedded in your printer, is well
below the RF exposure limits as set by the FCC.
This transmitter must not be collocated or operation in conjunction with any other antenna or
transmitter.
Operation of this device is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation of the device.
Wireless devices are not user serviceable. Do not modify them in any way. Modification to
a wireless device will void the authorization to use it. Contact manufacturer for service.
FCC Statement for Wireless LAN use:
While installing and operating this transmitter and antenna combination the radio
frequency exposure limit of 1m W/cm2 may be exceeded at distances close to the antenna
installed. Therefore, the user must maintain a minimum distance of 20cm from the
antenna at all times. This device cannot be collocated with another transmitter and trans-
mitting antenna.
RFID (Radio Frequency Interface Device)
RFID operation is subject to the following two conditions:(1) this device may not cause
interference, and (2) this device must accept any interference, including interference that may
cause undesired operation of the device. (U.S.A., France, Taiwan only)
Taiwan only
Regulatory information | 115