Wildview STC-TGL2M User Manual page 12

Wildview Series
conditions.
b. On – Flash on for every image captured
c. Off – No Flash will go off.
4. Select Burst mode: Slide the switch to 1 / 2 / 3 / AVI
position. If you choose AVI mode, the camera will
automatically switch to 1 picture mode if it detects a
low light source.
5. Turn on the Camera to set the Date / Time stamp
a. Slide the power switch to the PIR position
b. Press and hold [SET] button for 2 seconds to
enter date & time setting mode.
c. Time and HH will blink. Press [UP] or [DN] to
adjust the hour
d. Press [SET] button to enter minute setting. Time
and MM will blink. Press [UP] or [DN] to adjust
the minute.
e. Press [SET] button to enter the month setting.
Date & MM will blink.
adjust month.
www.wildviewcam.com
Press [UP] or [DN] to
Toll Free 888-304-6125 12