Overview; Assumption; System Requirements; Verify Package Contents - ADC Megabit Modem 500L Installation Manual

O
VERVIEW
There are several different scenarios to install the Megabit Modem. While one
installation may require only the physical setup (pre-configured modems), another
installation may require each of the steps mentioned in this document plus additional
configuration specified by your service provider. In any case, you may use this guide
as a basis to complete the installation.
In steps 2 and 3, each screenshot has a number at the bottom left corner. This number
corresponds to the procedure step number to the left of the screenshot.
A
SSUMPTION
Both the service provider and the subscriber sides of an ADSL link must be properly
configured for a successful installation. The subscriber side is the modem you are
installing. The service provider side is your service provider's equipment. It is
assumed that your service provider has made the necessary configurations on their
equipment to make the connection to your modem.
S R
YSTEM EQUIREMENTS
• PC with an Ethernet Network Interface Card (NIC)
• TCP/IP network protocol stack (see documentation for your operating system)
•
Web browser installed such as Netscape Navigator or Internet Explorer (Version
4.0 or higher)
V P
ERIFY ACKAGE
• Megabit Modem
•
one black patch cable
•
one grey phone cord (with RJ11 connectors)
• one flat grey cable for RS-232 MGMT port with DB9 connector included (600F
and 700F only)
• power supply and optional power cord
C
ONTENTS