Mounting The Base On A Wall - Radio Shack pmn Owner's Manual

43-5514.fm Page 8 Wednesday, August 18, 1999 12:47 PM
Installation

MOUNTING THE BASE ON A WALL

Note: To mount the base directly on the wall, you need two screws
(not supplied) with heads that fit into the keyhole slots on the bot-
tom of the base. Drill two holes 3
above the other. Then thread a screw into each hole, letting the
heads extend about
1
Plug one end of the sup-
plied modular cord into the
modular cord jack and the
supplied AC adapter's barrel
plug into the
the back of the base.
2
Route the adapter cord
and modular cord through the
channel slots on the bracket's
narrow end. Wrap the excess
modular cord in the groove in
the bottom of the base. Route
the end of the adapter cord
through the channel slot at
the bottom of the base.
3
Plug the modular cord's
loose end into the wall plate
jack (or a modular phone line
jack), align the base's key-
hole slots with the wall plate
studs (or the screws in the
wall), and slide the base
downward to secure it.
4
Plug the adapter into a
standard AC outlet. Fully ex-
tend the base's antenna and
raise it to a vertical position
8
15
/
16
5
/ inch (7 mm) from the wall.
16
Modular Cord Jack
jack on
POWER
inches (100 mm) apart, one
POWER Jack