Specific Operation Warnings - NorthStar 53009 Owner's Manual

8-gallon electric air compressor

Hide thumbs

Table Of Contents

Table of Contents



Moisture in supply air when compressed will form into droplets as it leaves air compressor pump

and enters receiver tank. When humidity is high or when a compressor is in continuous use for an

extended period of time, a significant amount of moisture will collect in the tank. Part of the

moisture will be discharged in the outlet air. When using a paint spray or sandblast gun, this water

will be carried from the tank through the hose, and out of the gun as droplets mixed with the spray

material. If this is not acceptable for your application, an external air dryer must be added to the

system.



The ideal operating temperatures is 40° and 100°F (4° and 37° C), the operating limitations is

15°F (-9°C) or above 125°F (52°C). If temperatures consistently drop below 32°F (0°C), install

within a heated building. If this not possible, protect the safety/relief and drain valves from

freezing.



The supply air is passing through the compressor supply hoses and tools. These can be damaged

or have a shortened life if unclean air is present or air filter is not clean and functioning properly.



Do not allow debris to accumulate or block airflow.



Do not place any objects against or on top of the unit, which can also block airflow or damage unit.



Rotating hazard. Keep hands and feet away from rotating parts, tie up long hair, remove jewelry,

and do not wear loose clothing.



Use only undamaged electrical cords.



Do not touch bare wires or receptacles.



Do not operate air compressor in wet weather or in wet conditions.



Do not touch air compressor or cords if hands or feet are wet.



Ensure that all cords are free of damage before connecting to the power supply.



Ensure that you have a sufficient electrical supply for supporting the requirements of the motor.



The pump of the compressor will become very hot during and immediately after use. Do not touch

any part of the pump of this compressor with bare hands other than the ON/OFF switch during and

immediately after use.



Allow the air compressor to cool before touching it.



Provide access to adequate, clean, and unobstructed airflow for cooling and air supply.



Do not allow debris to accumulate or block airflow.



Do not operate with a tarp, blanket, or storage cover surrounding the machine, which blocks air

flow. Only place a cover on the air compressor after it has thoroughly cooled down.