Mounting The Phone; On A Desk Top - Radio Shack ET-689 Owner's Manual

43-689.fm Page 7 Thursday, September 16, 1999 10:22 AM

MOUNTING THE PHONE

On a Desk Top

1. Remove the base's bracket by
pressing both tabs on the wide end,
then lifting off the bracket.
2. If you have a single 2-line modular
jack, plug one end of the supplied 2-
line long modular cord into
on the back of the phone's base.
L2
Note: When you make this connec-
tion, do not connect another modu-
lar cord to the
L2
the phone will not operate properly.
If you have two separate 1-line mod-
ular jacks, plug one end of the sup-
plied 2-line long modular cord into
and plug the other sup-
L1 OR L1/L2
3. Plug the supplied AC adapter's bar-
L1 OR L1/
4. Route the adapter's cord through
jack. Otherwise,
plied 2-line long modular cord into
.
L2
If you have a single 1-line modular
jack, plug one end of either supplied
long modular cord into
to use line 1, or into
L2
rel plug into the
DC 12V
back of the phone's base.
the right groove on the bottom of the
base.
L1 OR L1/L2
to use line 2.
jack on the
7