Connecting And Charging The Battery Pack - Radio Shack ET-689 Owner's Manual

43-689.fm Page 10 Thursday, September 16, 1999 10:22 AM
3. If you have a single 2-line modular
jack, plug one end of the supplied
long 2-line modular cord into
on the back of the phone's
L1/L2
base.
Note: When you make this connec-
tion, do not connect another modu-
lar cord to the
L2
the phone will not operate properly.
If you have two separate 1-line mod-
ular jacks, plug one end of the sup-
plied 2-line long modular cord into
and plug the supplied 2-
L1 OR L1/L2
line long modular cord into
If you have a single 1-line modular
jack, plug one end of either supplied
long modular cord into
to use line 1, or into
4. Plug the supplied AC adapter's bar-
rel plug into the
DC 12V
5. Route the adapter's cord through
the right groove on the bottom of the
base. Route the long modular cord
through the left groove on the bot-
tom of the base.
If you have connected two long
modular cords, route the cord con-
nected to
L1 OR L1/L2
right groove on the bottom of the
base, and route the cord connected
to through the hole in the center
L2
of the bracket.
6. Insert the tabs on the narrow end of
the bracket into the slots on the
base's bottom as shown, then push
the tabs on the wide end of the
bracket until it clicks securely into
place.
10
7. Plug the AC adapter into a standard
L1 OR
8. Plug the other end(s) of the cord(s)
9. Align the base's keyhole slots with
jack. Otherwise,
.
L2
10. Lift the base's antenna to a vertical
L1 OR L1/L2
to use line 2.
L2
jack.
CONNECTING AND
CHARGING THE BATTERY
PACK
The ET-689 comes with a rechargeable
nickel-cadmium battery pack in the
handset but not connected. Before using
your phone, you must connect the bat-
through the
tery pack, then charge it for about 15
hours.
1. Press down and slide off the battery
AC outlet.
into a modular phone line jack(s).
the mounting screws and slide the
base downward to secure it.
position.
compartment cover.