Radio Shack ET-689 Owner's Manual page 20

43-689.fm Page 20 Thursday, September 16, 1999 10:22 AM
Problem
The handset does not ring or
receive a page.
The handset stops working or
works poorly during a call.
The indicators for Lines 1 and
2 on your handset flash, but
there is no dial tone.
The Line 1 or Line 2 indicator
continuously flashes when you
are not using the phone.
If you still have problems, disconnect the phone. If other phones on the same line(s)
work properly, the fault is in this phone or its installation. If you cannot find the prob-
lem, take your phone to your local RadioShack store for assistance.
20
Suggestion
Fully extend the base's antenna and place it in
a vertical position.
Move the handset closer to the base.
Move the base away from other electrical
devices.
Return the handset to the base to recharge the
battery pack.
Move the handset closer to the base.
Fully extend the base's antenna and place it in
a vertical position.
Return the handset to the base for 6 seconds
to reset the handset.
Be sure the handset's battery is charged. (If
the battery power is too low, it might not have
enough power to light the BATT LOW indica-
tor.)
If the base loses power while the handset is
away from it, the security access-protection
code might change. Restore power to the
base, then place the handset back on the
base. The CHARGE indicator on the base
lights, indicating that the code is set again.
Check that the phone line cord(s) and the AC
adapter are properly connected at both ends.
Check to see if both lines are on hold.
Only one phone line is connected. Check that
both phone lines are properly connected.