Register New Transmitter; Tendency Indicators; Strength Indicator - Pantech WH2950 Operation Manuals

To restore the console to factory default, perform the following steps:
1. Remove the power from the console by removing the batteries and disconnecting the AC
adapter.
2. Apply power by connecting the AC adapter.
3. Wait for all of the segments to appear on the screen,.
4. Press and hold the WIND/+ and PRESSURE/- keys at the same time until the console
power up sequence is complete (about 5 seconds).
5. Replace the batteries.

6.8.2 Register New Transmitter

Press and hold the LIGHT /SNOOZE button for 5 seconds, and the console will re-register the
wireless sensor.
6.8.3 Backlight (constant backlight requires operation with AC adapter.)
1) With AC adaptor.
The backlight can only be continuously on when the AC adapter is permanently on. When the AC
adapter is disconnected, the backlight can be temporarily turned on.
Press the LIGHT SNOOZE key to adjust the brightness between High, Low and Off.
2) Without AC adaptor
To reduce power consumption, the display console will automatically enter sleep mode and will
not send data to the Internet i f no key is pressed for 15s. Hold the LIGHT /SNOOZE key in sleep
mode or plug in the DC adapter wake up equipment.

6.8.4 Tendency indicators

Tendency arrows allow you to quickly determine of temperature or pressure are rising and falling
in a three hour update period, updated every 30 minutes.
- 3 hrs comparison which changes on every ½ hour
Tendency
indicators
6.8.2 W
i
r
e
6.8.5 Wireless Signal Strength Indicator
T he wireless signal strength displays reception quality. If no signal is lost, the signal strength
indicator will display 5 bars. If the signal is lost once, four bars will be displayed.
Humidity
Rising Rising > 3%
Steady Change <= 3%
Falling Falling > 3%
Temperature
Rising >= 1C/2F
Change < 1C/2F
Falling >= 1C/2F
28
Pressure
Rising > 1hpa
Change <= 1hpa
Falling > 1hpa