Cornelius ED300 Instalation Instructions page 5

B. Position the ice maker base on the gasket located on the lid assembly.
IMPORTANT: DO NOT slide the ice maker into position on the lid.
C. Lift and set the ice maker base onto the lid to avoid damaging the gasket seal.
7. Install the brackets (item 5) on the rear corners of the ice maker, using the brackets as a template. Use
care not to drill into any ice maker components (condenser, tubing, etc.) or into the ice hopper. Be sure to
overlap the lid assembly with the brackets, installing screws in both the lid assembly and ice maker.
8. Install the wireform bracket supplied with the bin–stat kit (item 4) through the 5/8" diameter hole in the bot-
tom of the ice maker, wrapping the eye of the wireform over the stud near the hole in the ice maker and
secure with the 8–32 nut provided (Figure 3. and Figure 4.) Feed the bin–stat cap tube through the hole to
the end of the wireform bracket and wrap the tube around the end of the bracket several times, insuring
that the tube is secure.
!
CAUTION:
The bin–stat must not interfere with the agitator rotation not be in the path of the ice falling from the ice maker. If so,
bend the bracket out of the way.
9. Apply the label (item 7) on the front of the cover.
© 2016, Cornelius Inc.
Figure 1. Parts
- 3 -
DF/ED300 Lid Kit Installation Instructions
Publication Number: 629087943TEINS