Using Flash; Using Tone Services On A Pulse Line; Paging - Radio Shack ET-1102 Owner's Manual

43-1102.fm Page 15 Tuesday, August 17, 1999 4:37 PM

USING FLASH

performs the electronic equiva-
FLASH
lent of a switchhook operation for spe-
cial services, such as Call Waiting.
For example, if you have Call Waiting,
press to answer an incoming call
FLASH
without disconnecting the current call.
Press FLASH again to return to the first
call.
Note: If you do not have any special
phone services, pressing
disconnect the current call.
USING TONE SERVICES
ON A PULSE LINE
Some special services, such as bank-
by-phone, require tone signals. If you
have pulse dialing, you can still use
these special tone services by following
these steps.
1. Be sure DIAL MODE
2. Dial the service's main number.
3. When the service answers, press
4. To reset the phone to pulse dialing,

PAGING

To page the person who has the hand-
might
FLASH set or to locate the handset when the
phone is not in use, press
The handset beeps for 2 seconds.
To have the handset beep for a full
minute, hold down
onds. To stop the beeping sooner, press
TALK
is set to P .
( ). Any additional numbers
TONE
you dial are sent as tone signals.
simply hang up or press
"Using FLASH" on Page 15).
PAGE/FIND
twice.
(see
FLASH
.
PAGE/FIND
for 2 sec-
15