Entering A Pause; Reviewing Memory Numbers; Dialing A Memory Number - Radio Shack ET-1102 Owner's Manual

43-1102.fm Page 18 Tuesday, August 17, 1999 4:37 PM
4. Press . A menu appears
SELECT
with the three options listed below.
Press s or t to choose an option, fol-
low the instructions listed, then
press .
SELECT
Edit Memory n . Edit the record as
described in Steps 5 through 8 of
"Storing a Name and Number in
Memory" on Page 16.
Delete Memory n
prompts you to confirm the deletion.
Move the cursor to
press or
SELECT
phone beeps, and
leted appears.
Go Back . Returns you to the list of
memory numbers.

Entering a Pause

In some telephone systems, you must
dial an access code (9, for example) and
wait for a second dial tone before you
can dial an outside number. You can
store the access code with the phone
number. However, you should also store
a pause after the access code to allow
the outside line time to connect. To en-
ter a 2-second pause, press
use s or t to select on the display. You
P
can add more pause entries for a longer
pause.
18

Reviewing Memory Numbers

To review your memory numbers, press
MEM
bers (0–9) appears with the name stored
with each number (or
you did not store a name).
To see the stored phone numbers, press
means it is longer than 14 digits. Press
. The display
Repeatedly press
or , then
Yes No
name display.
. The
DELETE
Memory n De- To exit the memory number list, press
MEM
To see a stored name and phone num-
ber at the same time, press
when the cursor is by a memory location
number. To exit this display without stor-
ing any changes, hold down
til the display clears.

Dialing a Memory Number

To dial a number stored in memory, lift
the handset and press
memory location numbers appears.
Choose a memory location (0–9) by
or pressing a number or by repeatedly
PAUSE
pressing s or t, then press
You can also dial a memory number by
pressing
and entering a memory location number.
. The list of memory location num-
<Memory n >
. An arrow to the right of the number
again to see the rest of the number.
to return to the
.
MEM.
first, then pressing
TALK
if
SELECT
un-
DELETE
The list of
.
TALK
MEM