Table of Contents
Advertisement
43-3805.fm Page 9 Wednesday, May 17, 2000 3:48 PM
4. Route the adapter's cord through the
strain relief slot on the bottom of the
base.
5. Plug the adapter into a standard AC out-
let.
6. Lift the base's antenna to a vertical posi-
tion.
On a Wall Plate or Wall
1. Insert the two tabs at the top of the nar-
row end of the supplied bracket into the
base's upper tab slots as shown, then
press down on the bracket's latches and
insert them into the lower slots.
2. Plug one end of the supplied short mod-
ular cord into the
TEL LINE
back of the base as in "On a Desk Top"
on Page 8.
3. Insert the supplied AC adapter's barrel
plug into the
DC IN 9V
Desk Top" on Page 8.
4. Route the adapter and modular cords
through the grooves on the bracket.
5. Plug the modular cord's other end into
6. Plug the adapter into a standard AC out-
7. Press and lift out the handset holder, flip
8. Lift the base's antenna to a vertical posi-
Note: To mount the telephone directly on a
wall, you need two screws (not supplied) with
jack on the
heads that fit into the keyhole slots on the
bottom of the base. Follow the steps under
"On a Wall Plate or Wall," then apply these
additional instructions for placement on a
jack as in "On a
wall.
1. Drill two holes 3
2. Plug one end of the supplied long modu-
Installation
the wall plate jack, then align the
bracket's keyhole slots with the wall
plate studs and slide the base down-
ward to secure it.
let.
it over as shown, then snap it back into
place so it holds the handset.
tion.
15
/
16
inches (100 mm) apart.
Then thread a screw
into each hole, letting
the heads extend about
5
/
inch (8 mm) from
16
the wall.
lar cord into the
TEL LINE
back of the base.
5
/
16
3
15
/
16
jack at the
9
Advertisement
Table of Contents
