Announce Only Feature - Radio Shack 43-3880 Owner's Manual

2. Press
SKIP/SELECT
REPEAT/SELECT
message record time appears.
3. Press to select the new recording
SET
time.
A confirmation tone sounds, the system
announces the new record time.

Announce only feature

The Announce only feature plays a pre-
recorded outgoing message or your own
personal outgoing message, but it will not
allow the caller to leave a message. To set
"Announce only", follow the steps on page
56. To choose between the pre-recorded
message or your own personal greeting,
press , when the outgoing message is
OGM
played. Press
OGM
your choice.
If you want to use your own greeting, you
may want to change your greeting to omit
the prompt to leave a message. Refer to
"Recording a personal outgoing message
(Greeting)" on page 53.
The following message is pre-recorded:
"Hello, no one is available to take your call.
Please call again."
Setting the message alert
Message Alert feature lets you know when
you have a new incoming message by
sounding a short alert tone.
If you set the Message Alert On, and when
a new message is received, the alert tone
will sound every 15 seconds. Set the
Message Alert to On or Off by using
.
CLOCK/MENU
1. Press
CLOCK/MENU
current setting (
the base and it is announced.
or
until the desired
to select the greeting of
five times. The
or ) appears on
57