Mounting Directly On The Wall - Radio Shack ET-928 Owner's Manual

43-1098.fm Page 9 Tuesday, August 17, 1999 4:03 PM

Mounting Directly on the Wall

For this mounting method, you need two
wood screws (not supplied) with heads
that fit into the keyhole slots on the
mounting bracket.
1. At the desired mounting
location, drill two holes
3 15 / inches (100 mm)
16
apart. Then thread a
screw into each hole,
letting the heads extend
3
about / inch (5 mm)
16
from the wall.
2. Push in the two tabs on the top of
the mounting bracket, then lift off the
entire bracket.
add illus -- like the one
below Step 1 of
previous section
3. Plug one end of the supplied long
modular cord into the phone line
jack on the back of the base, then
press the cord into the center
groove on the bottom of the base.
4. Insert the AC adapter's barrel plug
into the
the base. Then route the cord
through the strain relief slot and
press the cord into the groove on
the bottom of the base.
3
/
16
15
3 /
16
5. Position the mounting bracket with
the narrow end on top. Insert the
two tabs at the top of bracket into
the matching slots on the base's
back, near the jacks.
Press the two tabs at the bottom of
the bracket into the matching slots
on the back of the base to lock the
bracket into place.
jack on the back of
DC 9V
illus -- label strain
relief slot
9