Maintenance Checklist - Roberts Gorden CRT-10 Installation, Operation & Service Manual

Corayvac series custom-engineered, low-intensity infrared heating systems
Table of Contents

Advertisement

12.3 Maintenance Checklist

The Vicinity of the Heater Do not store or use flammable objects, liquids or vapours near the heating
Vehicles and Other
Objects
Reflector
Vent Pipe
Outside Air Inlet
Tubes
Gas Line
Combustion Chamber
Window
Burner Head and Orifice
Installation, Service and Annual Inspection of the heater must be done
by a contractor qualified in the installation and service of gas-fired
heating equipment.
Read this manual carefully before installation, operation, or service of
this equipment.
system. Immediately remove these items if they are present.
See Page 4, Section 3.
Maintain the clearances to combustibles.
Do not hang anything from, or place anything on, the heater.
Make sure nothing is lodged underneath the reflector, in between the tubes
or in the decorative or protective grilles (included with select models).
Immediately remove objects in violation of the clearances to combustibles.
See Page 4, Section 3.
Make sure there is no dirt, sagging, cracking or distortion.
Do not operate if there is sagging, cracking or distortion.
Make sure reflectors are correctly overlapped.
Clean outside surface with a damp cloth.
Venting must be intact. Using a flashlight, look for obstructions, cracks on
the pipe, gaps in the sealed areas or corrosion.
The area must be free of dirt and dust.
Remove any carbon deposits or scale using a wire brush.
Inlet must be intact. Look for obstructions, cracks on the pipe, gaps in the
sealed areas or corrosion.
The area must be free of dirt and dust. Clean and reinstall as required.
Make sure there are no cracks.
Make sure tubes are connected and suspended securely.
See Page 10, Figure 8 through Page 13, Section 5.2.1.
Make sure there is no dirt, sagging, bending or distortion.
Clean or replace as required.
Check for gas leaks. See Page 31, Figure 23.
Make sure it is clean and free of cracks or holes.
Clean or replace as required.
Clear of obstructions (even spider webs will cause problems).
Carefully remove any dust and debris from the burner.
SECTION 12: S
I
ERVICING
NSTRUCTIONS
37

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Crt-15Crt-30Crt-20Crt-25

Table of Contents