Answering A Call - Radio Shack CT-502 Owner's Manual

17-1111.fm Page 16 Wednesday, July 21, 1999 2:23 PM
System Busy Message
In addition to the normal busy signal you hear when a num-
ber you call is busy, your phone sounds tones and displays a
message to indicate other situations when it cannot complete
a call.
Tone Display Shows
Fast Busy
SND to
Redial
High/low
SND to
Redial
When either of these conditions occur, you can press
again to redial the number immediately (see "Using Automat-
ic Redial" on Page 20), or press
again.

ANSWERING A CALL

When the phone receives an incoming call, it rings or vibrates
(depending on the alert setting — see "Changing the Alert
Type" on Page 29) and Call
swer the call, press
SND
Notes:
• Your phone can receive calls even if the antenna is not
extended. For optimum performance or if the signal
strength becomes weak, however, extend the antenna.
16
Description
The cellular system is
busy.
The cellular system
could not complete the
call.
then dial the number
END
flashes on the display. To an-
. To end the call, press
END
SND
.