Replacing The Rear Cover - Beijer Electronics EPC TA100 AM Service Maintenance Manual

6.2

Replacing the Rear Cover

The following is needed:
A new rear cover, see
•
A torx T10 screwdriver
•
Note:
Make sure to use adequate ESD protection.
Follow the steps below to replace the rear cover:
1. Power off the Panel PC.
2. Remove the rear cover of the Panel PC by loosening the 4 torx screws.
3. Re-assemble with the new rear cover in reverse order.
Beijer Electronics, MAEN043
Available Spare Parts for EPC TA100 AM
4 x torx screws
Hardware Replacement
18