Advertisement
Optimizing packet communication setup
The method of optimizing the PC packet
communication setup for FOMA network by means of
W-TCP setup and canceling optimization is explained
here.
The W-TCP setup is a TCP parameter tuning tool for
optimizing TCP/IP transmission capacity during packet
communication in the FOMA network. To enable
communication capability of FOMA terminal to
maximum extent, this communication setup is
required.
For Windows XP
System optimization can be performed for each
dialup connection.
設定ソフト
1
Start FOMA PC
設定
Click W-TCP
■
Starting from the task tray: Click
2
Perform the following:
■
When the system has not been optimized:
a Click
最適化を行う
screen
b Select the dialup connection to be
z
optimized
Click
Optimization of the system settings and
dialup settings are performed respectively.
■
When the system has been optimized:
The following screen appears. Make the
required settings if changes are to be made.
z
(☛P7)
on the W-TCP setting
実行
(Execute)
13
■
Deactivating optimization:
a Click
システム設定
設定
the W-TCP
W-TCP (dialup)) screen
The W-TCP setting screen appears.
b Click
最適化を解除する
optimization)
3
Reboot the PC, following the instruction
shown on the screen
･
The settings take effect after rebooting the PC.
Under Windows 2000, Me or 98
1
設定ソフト
Start FOMA PC
設定
Click W-TCP
■
Starting from the task tray: Click
2
Perform the following:
■
When the system setting has not been
optimized: Click
■
When canceling optimization of the
system setting: Click
3
Reboot the PC, following the instruction
shown on the screen
･
The settings take effect after rebooting the PC.
Setting dialup connections (APNs)
Set the dialup connection (APN) for packet
communication.
Up to 10 dialup connections (APNs) can be set, which
are to be registered under registration numbers (cid) 1 to
10 for management.
By default, "mopera.ne.jp" is set for cid1 and
"mopera.net" for cid3.
･
Before setup, make sure that FOMA terminal and
the PC are properly connected. ☛P3
･
For dialup connections (APNs) other than mopera
U / mopera, inquire your provider or network
administrator.
設定ソフト
1
Start FOMA PC
接続先
Click
(APN)
端末設定取得
The FOMA
2
Click OK
FOMA terminal is accessed for reading the
registered dialup connection (APN) information.
(System setting) in
ダイヤルアップ
) (Set
(
(Deactivate
z
(☛P7)
最適化を行う
最適化を解除する
z
(☛P7)
設定
screen appears.
Next
Advertisement
