Wall-Plate Mounting - Radio Shack Caller ID System 1500 Owner's Manual

43-976.fm Page 8 Monday, August 16, 1999 4:38 PM
3. To have the phone tilt slightly for-
ward, insert the tabs on the nar-
row end of the stand into the
matching slots near the bottom of
the phone. Then snap the stand
into place by pressing in the two
tabs toward the top of the phone.
4. Place the phone on a desk.

Wall-Plate Mounting

1. Plug one end of the supplied short
modular phone cord into the
jack on the phone.
LINE
8
2. Route the cord through the groove
on the back of the phone.
3. Insert the tabs on the narrow end
of the stand into the matching
slots near the top of the phone,
making sure the cord is routed
through the opening in the stand.
Then snap the stand into place by
pressing in the two tabs toward
the bottom of the phone.
TEL.
4. Plug the other end of the supplied
short modular phone cord into the
modular phone jack in the wall
plate.