Keithley PIO-96 Instruction Manual page 19

PIO-96 User's Manual
Install the DriverLINX software and board as follows:
1. Place the DriverLINX PIO Series CD-ROM in your drive and wait a few seconds. On most
systems, setup starts automatically. If not, run the setup.exe file, found in the root directory
of the CD-ROM.
A DriverLINX Browser Introduction screen appears. Thereafter, the DriverLINX CD Nav-
igator screen appears automatically after waiting a few seconds or after clicking Next .
NOTE On the DriverLINX CD Navigator and other DriverLINX Browser
screens, place the cursor over a menu item to see an explanation. A star
next to a menu item means that it was selected previously.
Before continuing with this installation, Keithley suggests clicking Read
Me First on the DriverLINX CD Navigator and reviewing the brief
information that appears.
2. On the DriverLINX CD Navigator screen, click Install DriverLINX . An Install These
DriverLINX Components screen appears.
3. Click Install Drivers , and then follow the series of on-screen instructions. When done, the
Install These DriverLINX Components screen reappears.
4. If you do not plan to develop custom application software for your PIO-96 board, then skip
to Step 5. If you do plan to develop custom application software, you must install Driver-
LINX interfaces before writing the software. Install them now by clicking Install Inter-
faces and following the series of on-screen instructions. When done, the Install These
DriverLINX Components screen reappears.
5. Click Install Documentation and follow the series of on-screen instructions. This step
installs the manuals. When done, the Install These DriverLINX Components screen reap-
pears.
6. If Acrobat Reader is not already installed on your system, install it now. You need Acrobat
Reader to read the manuals, a section of which you must access in step 9. Click on Install
Acrobat and follow the series of on-screen instructions. When done, the Install These
DriverLINX Components screen reappears.
7. Click Exit. Then, on the screen that appears saying "Thank you for using DriverLINX,"
click Done . The System Settings Changed dialog box appears.
8. On the System Settings Changed dialog box, click No . (The system will be rebooted and
configured later under "Configuring your installation" on page 2-4.) The screen returns to
the Windows desktop.
9. Print out one section of a DriverLINX manual that you will briefly review later during sys-
tem configuration. Proceed as follows:
a. In the Start menu under Programs → DriverLINX, click On-line Manuals. A menu
document appears
b. In the menu document, scroll until you find the major category Configuration .
c. Under Configuration click Hardware References . A list of documents appears.
d. In the list of documents, click Keithley PIO Series . Acrobat Reader opens and the
manual entitled Using DriverLINX with Your Hardware—Keithley PIO Series appears.
Installation 2-3