Connecting The Handset - Radio Shack TAD-285 Owner's Manual

43-785.fm Page 10 Monday, August 16, 1999 7:54 AM
4. Align the adapter's power cord
with the left slot on the top and
bottom of the mounting bracket.
Align the modular cord with the
right slot on the top and bottom of
the mounting bracket.
5. Insert the mounting bracket's tabs
into the slots on the bottom of the
answering system. Then pull the
bracket up until it snaps into
place.
Illust.
6. Plug the modular cord into a mod-
ular phone jack.
7. Line up the keyhole slots on the
bracket with the screws on the
wall, then slide the bracket down
onto the screws until it is secure.
Illust.
10
8. Pull the handset holder toward
you as far as it will go. Hold it out
as you rotate the holder 180°,
then let it snap back in place.
Illust.
The holder's tab helps hold the
handset in the cradle while the
answering system is mounted on
the wall.
9. Proceed to "Connecting the Hand-
set" on Page 10.
CONNECTING THE
HANDSET
Plug one end of the coiled handset
cord into the answering system's
handset jack. Plug the other end into
the jack on the handset. Place the
handset on the cradle.
Illust.