Cisco UBR-MC20X20V Hardware Installation Manual page 4

Overview
The figure below shows the rear view (CMTS side) of the upstream-only version of the
Cisco UBR-RFSW-ADV.
Figure 4: Upstream-Only Version of Cisco UBR-RFSW-ADV — Rear View (CMTS Side)
1 Upstream switch card
The table below lists the Cisco UBR-RFSW-ADV chassis dimensions.
Table 1: Cisco UBR-RFSW-ADV Chassis Dimensions
Unit
Chassis Depth
Chassis Width
Chassis Height
Two types of rack-mounting are supported for the Cisco UBR-RFSW-ADV:
• Mounting a Single Cisco UBR-RFSW-ADV Above a Cisco uBR10012 Universal Broadband Router
• Mounting Two Cisco uBR10012 Universal Broadband Routers and Two Cisco UBR-RFSW-ADVs in
a Single Rack
Note For more details on rack-mounting, see
uBR10012
For more information about the Cisco UBR-RFSW-ADV product identifiers (PIDs), see
Cisco uBR Advanced RF Switch Hardware Installation Guide
4
Dimension
17.70 in (44.96 cm)—measured from front connector panel face to rear connector panel
face
19.46 in (49.43 cm)—measured from front connector handle to rear connector handle
17.28 in (43.89 cm)
3 rack units
Router.
2 Upstream protect cards
Rack-Mounting the Cisco UBR-RFSW-ADV with the Cisco
Introduction
Power Requirements.
OL-24104-01