Cisco UBR-MC20X20V Hardware Installation Manual page 14

Controller Card
LED
Power/System
Failover (FO)
COM 0/COM
1
The controller card provides the following high-level status information to the PRE:
• General health of the Cisco UBR-RFSW-ADV
• Version information
• Command history
• Command status (success or failure)
• Operational status (active or standby status of the relays)
• Status of switchover or revertback request sent by the PRE
For information about the controller PIDs, see
Product
Cisco uBR Advanced RF Switch Hardware Installation Guide
14
Color/State
Off
Green (blinking)
Green
Amber
Off
Blue
Off
Green
Identifiers.
State Description
Card is not powered on.
Card is either powering on and is in the process of configuring the
system, or the Cisco UBR-RFSW-ADV is in the process of downloading
and reconfiguring the system.
Normal operation.
Alarm condition.
System in pass-through mode.
System has completed a line card failover and is still in the failover
configuration.
Communication link to the Cisco uBR10012 router is not established.
Communication link with the Cisco uBR10012 router is established.
Cisco UBR-RFSW-ADV Components Part Numbers and
Introduction
OL-24104-01