Troubleshooting; Installation - Zanussi ZEV6140NBA User Manual

• Scratches or dark stains on the surface have no
effect on how the hob operates.
• Use a special cleaner applicable for the surface
of the hob.
• Use a special scraper for the glass.
CLEANING THE HOB
• Remove immediately: melted plastic, plastic
foil, sugar and food with sugar. If not, the dirt
can cause damage to the hob. Take care to
avoid burns. Put the special scraper on the

TROUBLESHOOTING

WARNING! Refer to Safety chapters.
WHAT TO DO IF...
Problem
You cannot activate or operate
the hob.
Residual heat indicator does
not come on.
IF YOU CANNOT FIND A SOLUTION...
If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service
Centre. Give the data from the rating plate. Give
also three digit letter code for the glass ceramic (it
is in the corner of the glass surface). Make sure,
you operated the hob correctly. If not the servicing

INSTALLATION

WARNING! Refer to Safety chapters.
BEFORE THE INSTALLATION
Before you install the hob, write down the
information bellow from the rating plate. The rating
plate is on the bottom of the hob.
glass surface at an acute angle and move the
blade on the surface.
• Remove when the hob is sufficiently cool:
limescale rings, water rings, fat stains, shiny
metallic discoloration. Clean the hob with a
moist cloth and non-abrasive detergent. After
cleaning, wipe the hob dry with a soft cloth.
• Remove shiny metallic discoloration: use a
solution of water with vinegar and clean the
glass surface with a moist cloth.
Possible cause
The hob is not connected to an
electrical supply or it is con-
nected incorrectly.
The fuse is blown.
The zone is not hot because it
operated only for a short time.
by a service technician or dealer will not be free of
charge, also during the warranty period. The
instructions about the Service Centre and
conditions of guarantee are in the guarantee
booklet.
Serial number ...........................
BUILT-IN HOBS
Only use the built-in hobs after you assemble the
hob into correct built-in units and work surfaces
that align to the standards.
Remedy
Check if the hob is correctly
connected to the electrical
supply. Refer to the connection
diagram.
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
If the zone operated sufficiently
long to be hot, speak to an Au-
thorised Service Centre.
7