Advertisement
Changes or modifi cations not expressly approved
by Bosch Security Systems, Inc. can void the user's
authority to operate the equipment.
UL
Perform Walk Test at least once a year.
Use only a Listed limited-power source.
The Listed control unit or a Listed burglary power
supply must provide 4 hours (20 mAh) of standby
power.
Install the unit in accordance with National
Electrical Code NFPA 70.
Adjust the microwave range control, if necessary, to
achieve maximum range.
SELV
Connect all wiring to a safety extra-low voltage (SELV) circuit only.
Ligue todas as cablagens apenas a um circuito de segurança de tensão extra baixa (SELV).
Conecte el cableado únicamente a un circuito de seguridad para voltajes muy bajos (SELV).
Alle Drähte sind ohne Ausnahme an Niederspannung anzuschließen.
Sluit alle bedrading uitsluitend aan op een circuit met een extra lage veiligheidsspanning.
Prenez soin de connecter tous les câbles à un circuit à très basse tension de sécurité (TBTS).
Collegare tutti i cavi esclusivamente a un circuito SELV (circuito di sicurezza a bassissima tensione).
Region
Certifi cation
Europe
CE
AFNOR
Poland
TECHOM
USA
UL
Sweden
INTYG
Trademark names are used throughout this document. In most cases, these designations are claimed as
trademarks or registered trademarks in one or more countries by their respective owners. Rather than
placing a trademark symbol in every occurrence of a trademark name, Bosch Security Systems, Inc.
(hereinafter referred to as Bosch) uses the names only in an editorial fashion and to the benefi t of the
trademark owner with no intention of infringing the trademark.
2 © 2013 Bosch Security Systems, Inc.
-29°C to +50°C
(-20°F to +120°F )
UL Listed
installations,
the temperature
range is 0°C to +50°C
(+32°F to +120°F)
0 - 95% Relative Humidity
(0 - 85% UL Installations)
EN 50131-2-2 Grade 2
EN 50130-5 Environmental Class II
IP30 IK04 (EN 60529, EN 62262)
Certifi cat NF A2P 2620001760A1
2 boucliers NF324 - H58
Autosurveillance à l'ouverture
Immunité champ magnétique
Test sans masque de vision verticale
et sans immunité aux animaux
www.afnor.org
www.cnpp.com
EN50131-2-2, Grade 2
EN50130-5 Environmental Class II
2620001760A1
98/07 Klasy "C"
ANSR: Intrusion Detection Units
(UL639)
04-683
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
7.2 Selecting the Optical Module
1. For ceilings between 8 and 13 ft. (2.4 and 4.0 m) from the fl oor, use
the optical module marked AR8-13. This marking can be found next to
the two optical module tabs.
2. For ceilings between 13 and 18 ft. (4.0 and 5.5 m) high, use the optical
module marked AR13-18.
3. To replace an optical module, push the optical module tabs towards
the center until the module snaps free of the circuit board. Holding the
new module by the tabs, snap the new module into place.
NOTICE!
When replacing the mirror, make sure it is facing the same
direction as before it was removed.
4. Replace the enclosure onto the base.
5. Close cover and turn clockwise to secure.
NOTICE!
Avoid fi ngerprints on the mirrored surfaces. Should the mirrored sur
faces become soiled or otherwise marked, they can be cleaned using a
soft, clean cloth and any commonly available, mild window cleaner.
BASEBOARD
WINDOW
Figure 7.2: Masking
8 Coverage
•
360° by 60 ft. (18.3 m) diameter coverage when mounted on 8 to 18 ft
(2.4 to 5.5 m) high ceilings.
• The coverage pattern consists of 64 zones grouped into 16 barriers,
with one additional zone looking straight down from the unit
(sabotage). Each barrier is 30 ft (9.2 m) long and 4.4 ft. (1.3 m) wide
at 30 ft (9.2 m).
• The DS9382 comes with a choice of two optical modules. Refer to
Section 5.1 to determine the best module for on ceiling height.
AR8-13
1
2 3 4
5
4 3 2 1
4
3
2
1
5
1
2
3
HEAT
MASK 3
SECTORS
AR8-13
1
2 3 4
5
4 3 2 1
4
1
5
1
2
3
MASK 15
SECTORS
F.01U.263.663 | 04 | 2013.04 | 11
Advertisement
