Table of Contents
Advertisement
Ethernet Interface (Fiber, SFP)
For both 100/1000 Mbps fiber speed connections, the SFP slots are available. The SFP slot
accepts the fiber transceivers that typically have an LC connector.
The fiber transceivers have options of multimode, single mode, long-haul or special-
application transceivers.
DANGER:
Never attempt to view optical connectors that might be emitting laser energy.
Do not power up the laser product without connecting the laser to the optical
fiber and putting the dust cover in position, as laser outputs will emit infrared
laser light at this point.
Connecting Power Terminal Block
The switch can be powered from two power supplies (input range 12V – 58V). Insert
the positive and negative wires into V+ and V- contacts on the terminal block
respectively and tighten the wire-clamp screws to prevent the wires from being
loosened.
Note:
The DC power should be connected to a well-fused power supply.
DIS-300G12SW
Quick Installation Guide
4
Advertisement
Table of Contents
