Remote Control Operating Range; Projector And Remote Control Buttons; Remote Control Code - Eiki EK-623U Owner's Manual

Hide thumbs Also See for EK-623U:

Table of Contents

DLP Projector — Owner's Manual

Remote Control Operating Range

The remote control uses infrared transmission to control the projector. It is not necessary to point the

remote directly at the projector. Provided you are not holding the remote perpendicular to the sides or the

rear of the projector, the remote will function well within a radius of about 10 meters (32.8 feet) and 30

degrees above or below the projector level. If the projector does not respond to the remote control, move

a little closer.

The projector can be operated using the remote control or the buttons on the rear of the projector. All

operations can be carried out with the remote control; however, the buttons on the projector are limited in

use.

The ten different remote control codes (Code 0- Code 9) are assigned to this projector. Switching the

remote control codes prevents interference from other remote controls when several projectors or video

equipment next to each other are being operated at the same time. Change the remote control code for

the projector first before changing that for the remote control. See "Remote Settings → Projector Address"

in the Options Menu on page 39.

To change the code for the Remote Control:

Press and hold the Mode button and a number button (0-9) on the remote control for more than three

seconds to switch among the codes.

Default setting: 0

To change the Projector Address for the projector:

Select a Projector Address in the Options Menu. (Options → Remote Settings → Projector Address)

—

Table of Contents