Wiring Diagram; Key To Abbreviations - Smeg GW0160 Technical Manual

4 WIRING DIAGRAM

In revision 04 of the present Technical Manual, the wiring diagram is cancelled from this section
to leave only the official updated reference, on www.smegtech.com, for authorized tecnicians.
For complete up-to-date digital documentation always consult

5 KEY TO ABBREVIATIONS

AQS: Acquastop (optional) - microswitch
BPE: Electric lock
DD: Powder detergent dispenser (GW series only)
EVCC: Condenser filling solenoid valve
EVD: Demineralised water solenoid valve
EVF: Cold water solenoid valve
EVR: Softener resin regeneration solenoid valve
FMD (FLMT_D): demineralised water flowmeter
FMF (FLMT_F): Cold water flowmeter
FLSW1, FLSW2, FLSW3: detergent dispensing flow switches
KR: Chamber heating element control relay
MA: Dryer motor
MCM: Door closure microswitch
ML: Washing pump
MS: Chamber drain pump
P1, P2, ..., P10: PCB connectors
P1, P2, P3: Peristaltic detergent feeder pumps (P3 is always optional)
PAP: High pressure switch (for monitoring operation of washing pump ML)
PLA: chamber safety/level analogue pressure sensor
PLC: Condenser pressure switch (used as level sensor in the steam condenser)
PSC: Steam condenser drain pump
R1, R2, R3: Chamber heating elements
RA: Drying System heating element
SF: RFI filter
SL1, SL2, SL3: Detergent jerry can level sensors
SS: Salt sensor (salt level in integral softener tank)
TA: PT1000 probe for drying system air temperature
TCL: PT1000 probe for monitoring chamber water temperature
THS1: Safety thermostat for heating element R1
THS2, THS3: Safety thermostats for R2, R3
TL1: PT1000 probe for chamber water working temperature
TS1, TS2: Drying heating element safety thermostats
X1: Main terminal board (power supply)
XCT: "Voltage change" terminal board
www.smegtech.com
5