How to setup Jumper
The illustration shows how jumpers are setup . When the Jumper cap is placed on pins, the
jumper is "close". If no ju mper cap is placed on the pins, the jumper is "open". The
illustration shows a 3-pin ju mper whose pin 1and 2 are "close" when jumper cap is placed
on these 2 pins.
Jumper close
CPU Installation
Step1:
Pull the le ver sideway s away from the socket and then raise the lever up to a
90-degree angle.
Step2:
Look for the white dot/cut edge. The white dot/cut edge should point towards the
lev er piv ot. The CPU will f it only in the correct orientation.
Step3:
Hold the CPU down f irmly, and then close the lever.
Step4:
Put the CP U f an on the CPU and buckle it. Connect the CPU fan power cable to
the JCFAN1. This completes the installation.
Step1
Jumper open
Step2
Step3
5
Pin1-2 close
Step4