Using A Tripod; Connecting The Cables; Multi-Function Output Specifications; Gpi Input Specifications - Sony XCG-V60E Technical Manual

g POWER LED
Flashes or lights based on the internal status of the
camera.
Flashing: Obtaining IP address.
Lit: IP address obtained.

Using a Tripod

To use the tripod, install the tripod adaptor VCT-ST70I
(not supplied) on the camera module.
Use a tripod screw with a protrusion (4) extending from
the installation surface, as follows, and tighten it, using
a screwdriver.
4.5 to 5.5 mm
0.18 to 0.22 inches
Note
If you install a tripod adapter (not supplied), use the
screws provided.

Connecting the Cables

Connect the camera cable to the DC IN connector and
the LAN cable to the RJ45 connector respectively. When
you connect the LAN cable, turn the two fastening
screws on the connector to secure the cable tightly.
a DC IN connector
b RJ45 connector
c Camera cable
d LAN cable
e Fastening screws
Connect the other end of the camera cable to the
DC-700/700CE and the other end of the LAN cable to
the Network card.
8
Multi-Function Output
Specifications
When exposure output is selected, signal output is valid
during image sensor exposure. When strobe control
output is selected, output signal timing and pulse width
can be precisely set to control external devices such as
strobes connected to the camera. Output signal polarity
can be set for both exposure and strobe control outputs.
TTL output termination impedance should be at least
10 kΩ .
Illustrations of positive-polarity multi-function TTL
output.
Exposure Time
When using ISO (+ or -), be sure to use an external
power supply between +5 and +24 V DC in combination
with resistance.
Refer to the following circuit diagram.
TLP281
470 Ω
Multi-
function
output
3.3 V
Note
When GPO (fixed-value, general-purpose output) is
selected, the fixed output varies depending on the
register setting value.
Register setting value 0: fixed Low
Register setting value 1: fixed Hi

GPI Input Specifications

Be sure to use an external power supply between +5 and
+24 V DC in combination with resistance.
Refer to the following circuit diagram.
VCC3.3 V
1 kΩ
TLP281
GPI
4.8 to 5.2 V
220 Ω
ISO (+) [#6]
ISO (–) [#5]
470 Ω
ISO (+) [#7]
ISO (–) [#12]