Table of Contents
Advertisement
To connect the mouse, the keyboard, a LAN cable, a USB device, a printer, and a GPIB
cable
To connect the mouse, the keyboard, a LAN cable, a USB
device, a printer, and a GPIB cable
See Figure 1-5 for the location of the connectors.
Plug the mouse into the matching connector on the back panel of the
Mouse
oscilloscope. The connectors are labeled 1 and 5.
While you can operate many oscilloscope functions using only the front-panel keys and
knobs, you will need the mouse to access advanced oscilloscope functions through the
graphical interface, or to find out more about the oscilloscope through the built-in
information system.
Plug the keyboard cable into the connector labeled 2 on the back panel of the
Keyboard
oscilloscope.
A keyboard cannot be plugged into the oscilloscope after the Windows operating system
has started booting.
Connect your LAN cable to the RJ-45 connector labeled 3 on the back panel of
LAN Cable
the oscilloscope.
After you have connected to the LAN card, you must set up the network. Before you try
to setup your network, you should exit the oscilloscope application. If you do not know
how to setup a network in Windows XP, see your network administrator or use the
Windows XP on-line help.
USB
Connectors can be used for any USB devices. There is also a USB connector in
Connectors
the upper right-hand corner of the front panel.
If you have a parallel (Centronics) printer, you will need a parallel printer cable.
Printer Cable
Connect cable into the connector labeled 4.
If you have a serial printer, you will need a 9-pin to 25-pin serial printer cable.
Some printers may require other cable configurations, but the oscilloscope has
a 9-pin serial connector. Connect cable into the connector labeled 7.
Attach the GPIB connector to the GPIB interface card connector labeled 6 on
GPIB Cable
the rear of the oscilloscope.
Setting Up the Oscilloscope
1-15
Advertisement
Table of Contents
