Power Supply - Sony WRT-8P Operating Instructions Manual

Power Supply

WRT-8P can be powered by one 6LR61 (9V) alkaline battery for about five hours of
continuous operation (at 25°C, 77° F) .
The battery condition Indication are given below:
Battery indication
When you turn the power on, the battery condition is shown by the BATT indication
in the display section.
When the indication in column 4 starts to flash, replace the batteries with new one.
Be sure to check the expiration date printed on the new battery before using it.
NOTE
The indicated battery condition may not be correct if the battery was not new when
installed. If you plan to use the component for a long period, it is recommended that
you replace the battery with brand new one.
Notes on battery
Battery may leak or explode if mistreated. Be sure to follow these instructions.
• Be sure to install the battery with the correct polarity.
• The battery are not rechargeable.
• When not using the component for a long period of time, remove the battery to
avoid leakage. If the battery dose leak, clean all leakage from the battery
compartment and the component. Leakage left in the compartment and the component
may cause poor battery contact. If there seems to be poor battery contact, consult your
Sony dealer.
Inserting the battery
1 Slide the battery lid to release the lock
and open the battery compartment.
2 Align one new 6LR61 (9V) alkaline
battery with the polarity markings and
insert them into the battery compartment,
and then close the cover.
9