Table of Contents
Advertisement
1MRK 511 391-UUS A
670 series 2.2 ANSI
Communication protocol manual
For example, to navigate between the options, use
•
HMI menu paths are presented in bold.
For example, select Main menu/Settings.
•
LHMI messages are shown in Courier font.
For example, to save the changes in non-volatile memory, select Yes and press
.
•
Parameter names are shown in italics.
For example, the function can be enabled and disabled with the Operation setting.
•
Each function block symbol shows the available input/output signal.
•
the character ^ in front of an input/output signal name indicates that the
signal name may be customized using the PCM600 software.
•
the character * after an input signal name indicates that the signal must be
connected to another function block in the application configuration to
achieve a valid application configuration.
•
Logic diagrams describe the signal logic inside the function block and are
bordered by dashed lines.
•
Signals in frames with a shaded area on their right hand side represent
setting parameter signals that are only settable via the PST, ECT or LHMI.
•
If an internal signal path cannot be drawn with a continuous line, the suffix -
int is added to the signal name to indicate where the signal starts and
continues.
•
Signal paths that extend beyond the logic diagram and continue in another
diagram have the suffix "-cont."
•
Dimensions are provided both in inches and millimeters. If it is not specifically
mentioned then the dimension is in millimeters.
Illustrations are used as an example and might show other products
than the one the manual describes. The example that is illustrated is still
valid.
Section 1
Introduction
and
.
9
Advertisement
Table of Contents
