Table of Contents
Advertisement
Routing Setup
Typically static routing does not need to e setup ecause the router has ade uate routing information after it has een con gured
for Internet access. Static routing is only necessary if the router is connected to net ork under a different su nets.
To vie the Routing settings, click Advanced then select Routing.
Note: To ena le a static routing, AT must e disa led.
If the router is connected ith a net ork under the different
su net, the routing setup allo s the net ork connection ithin
t o different su nets.
Enable Static Routing
lick Ena le Static Routing to activate the feature.
Destination LAN IP
Enter the LA IP address of the destination device.
Subnet Mask
Enter the Su net ask of the destination device.
De ault Gateway
Enter the default gate ay IP address for the destination device.
Hops
Enter the ma imum num er of hops ithin the static routing
that a packet is allo ed to travel.
Inter ace
Select LA or A as the interface.
lick Add to save the settings and list the con guration in the
urrent Static Routing ta le or Reset the discard changes.
View and select devices in the Current Static Routing Table.
lick Delete Selected or Delete All to remove devices
from the ta le. lick Reset to stop.
lick Apply to save the settings or Cancel to discard changes.
12
Advertisement
Table of Contents
