Electrolux Iron Aid EDI97170W User Manual page 22

22 electrolux
After a IronAid pro-
gramme, there are no
creases left in the gar-
ments.
Drying results unsatisfac-
tory.
When a button is pressed
- no reaction of the ma-
chine.
Drum light does not work.
Displayed programme
time changes erratically
or stays unchanged for a
long time.
Programme inactive,
CONTAINER display illu-
minated.
Drying cycle ends shortly
after programme
starts. ANTICREASE
display illuminated.
Drying cycle lasts an un-
usually long time. Note:
After up to 5 hours the
drying cycle ends auto-
matically (see 'End of dry-
ing cycle').
Multi-layered garments tend to
lose their shape.
The IronAid programme has the ef-
fect of smoothing garments.
Wrong programme selected.
Lint filters clogged.
Fluff filter clogged.
Heat exchanger clogged with lint.
Overloading of laundry.
Ventilation slots in base area cov-
ered up.
Residue on inside surface of drum
or drum ribs.
Conductance of water at installa-
tion site differs from standard set-
ting of machine.
Drying protection. After the start of
the programme, the option can no
longer be set.
Programme selector in OFF posi-
tion.
Defective light bulb.
Programme time is corrected auto-
matically depending on type and
volume of laundry and level of
dampness.
Condensed water container is full.
Not enough washing loaded or
washing loaded is too dry for selec-
ted programme.
Lint filter clogged.
Fluff filter clogged.
Load volume too big.
Reshape multi-layered garments
by ironing after they come out of
the machine.
Iron creases in again after the Iron-
Aid programme.
Select a different programme the
next time you dry (see "Pro-
gramme overview" chapter).
Clean lint filters.
Clean fluff filter.
Clean heat exchanger.
Observe recommended loading
volumes.
Uncover ventilation slots in base
area.
Clean inside surface of drum and
drum ribs.
Make an adjustment using the
DRYNESS function (see chap-
ter "Drying")
Re-programme standard setting
for degree of drying (see 'Program-
ming options' chapter).
Turn the programme knob to
OFF . Set the programme again.
Turn programme selector to any
programme.
Replace light bulb (see next sec-
tion).
Automatic process; this is not a
machine fault.
Empty Condensed water contain-
er , then start programme with
START/PAUSE button.
Select time programme or higher
drying level (e.g. EXTRA in-
stead of CUPBOARD ).
Clean lint filter.
Clean fluff filter.
Reduce load volume.