Samsung DMR57 Training Manual page 37

Heater Replacement Part 2
5.
5) Lay the product down, Protect the washer and the customer's floor and
cabinets with a blanket, and unscrew the 2 screws securing the Base and the
Shutter. Disconnect the Leakage Sensor terminal 6)
terminal to the Heater, turn the Heater Holder in CCW direction to remove it. 7) Set
the product upright and open the door to pull out the heater from the inside. Be
careful of the interference with the Heater Bracket.
6.
7.
5) Lay the product down, and unscrew the 2
screws securing the BASE and the Shutter.
Separate the terminal of Leakage Sensor
terminal of the Shutter.
6) After disassembling the terminal inserted to the
Heater, turn the Holder Heater in CCW
direction to disassemble it.
7) Set the product upright and open the door to
pull out the heater. Be careful of the
interference with the Heater Bracket.
※ CHECK LIST
▶ Measure the resistance of the heater ends: 12Ω
(Measure after removing the connecting terminal)
▶ Check the relay connecting terminal and check the
operating signal
After disconnecting the
37