4. Send test email.
To Add or Modify a Target Email address:
1. Click on the Add or Modify icon.
2. Type email address and then click Save.
To Delete a Target Email address:
1. Click on the Delete icon next to the address you wish to delete.
2. Click the Delete button on the pop-up window to confirm.
To Send a Test Email:
1. Click on the Test Email icon next to the address you wish to test.
2. A pop-up window will indicate that the test Email is being sent. Click OK to dismiss the pop-up.
SNMP Page
Simple Network Management Protocol (SNMP) can be used to monitor the unit's measurements and status if
desired. SNMP v1, v2c and v3 are supported. In addition, alarm traps can be sent up to two IP addresses.
Figure 32: SNMP Page
GM1118 - Watchdog 100 Series User Manual BB3.0
25
Revision Date: 12/31/2015