y DAY/NIGHT: You can display pictures in color or in black and white.
If the SPECIAL menu screen is displayed, use the Function Setup switch so that
➊
the arrow indicates 'DAY/NIGHT'.
Select a desired mode using the Function Setup switch according to the picture
➋
display you want.
- AuTO : The mode is switched
to 'Color' in a normal
environment, but switches
to 'B/W' mode when
ambient illumination is low.
To set up the switching
time for AUTO mode, press the Function Setup switch. You can turn on or
off the burst signal on B/W mode.
y BURST MODE : Activate or deactivate the burst mode to maintain or remove
y DURATION : This function is used to select the brightness of light where
y DWELL TIME : You can select day/night switching delay time from.
M
`
If you set the AGC mode to off on the exposure menu, you cannot switch the day/night
mode to auto.
`
When a bright light source is in the screen or there are frequent brightness changes, if
you use the auto night/day mode, and set the switching time to short (3, 5 sec), a hunting
can be caused. In this situation, it is recommended to use the default setting (30 sec).
- COLOR : The picture is always displayed in color.
- B/W : The picture is always displayed in black and white.
You can turn on or off the burst signal on B/W mode.
M
`
If the lens mounted in the camera is different from the one set in <LENS> of the
<EXPOSURE> menu, then the night/day mode may not operate normally.
the color signal.
switching occurs.
3s, 5s, 7s, 10s, 15s, 20s, 30s, 40s, 60s
AuTO SETuP
▶
buRST MODE
1.
DuRATION
2.
DwELL TIME
3.
RETuRN
4.
ON
NORMAL
30 SEC
English_27