Table of Contents
Advertisement
14
Installation
HDD INSTALLATION
Note for Hard Disk Drive
The internal hard disk drive (HDD) is a fragile piece of equipment.
Please follow the guidelines below when using the system to protect
against possible HDD failure. We recommend that you back up your
important recordings onto an external backup device in order to
prevent accidental loss.
Make sure that the power is turned OFF when attaching or removing
the HDD.
•
Do not move the system while the power is on.
3
•
Do not move this device with the power on.
•
Do not use the system in excessively hot or humid places, or in
places that may be subject to sudden changes in temperature.
Sudden changes in temperature can cause condensation to form
inside the system. This can be a cause of HDD failure.
•
While the system is switched on, do not unplug from the wall
socket or switch the electricity off from the breaker switch.
•
If there' s a power failure while the system is on, some data on the
HDD may be lost.
•
Do not drop the HDD. Also do not put the metallic object such as
coins or screwdrivers into the HDD tray.
•
When a power failure occurs during recording, avoid adding,
replacing or transporting the HDD as the recorded data may be
erased. In this case, turn the power back on to boot up the unit
normally with the HDD that was being used at the time of the
power failure attached. Then add, replace, or transport the HDD.
•
The HDD is very delicate. Handle the HDD with care and follow
the precautions below because even a tiny shock may damage the
internal components of the HDD.
-
Do not place the HDD on the desk or table directly. Put a
thick cushion under the HDD because even a small shock may
damage the internal components of the HDD.
-
Do not use an electric screwdriver. Vibrations and shocks
caused by an electric screwdriver may damage the internal
components of the HDD.
-
When replacing the HDD, do not knock the HDD with other
components such as another HDD and the HDD tray.
-
Do not knock the HDD with tools such as a driver when
replacing the HDD.
•
Protect the hard disk drives from static electricity.
Installing the Hard Disk Drive
Improper installation or setup may disturb HDD (Hard Disk Drive)
recognition or normal product operation. So you should consult with
an expert from the store where the product was purchased.
NOTE
•
Turn the power of the unit off and detach the power plug
from the outlet before installation.
•
Do not use an electric screwdriver to fix them.
•
Deleted data can not be recovered. Make sure you back up
Important data before you use the HDD initializing function.
1. Remove the fixing screws on the left/right side and rear panel.
2. Detach the top case by sliding it after removing the screws. You
must slide the top case to the back side horizontally.
3. Attach the hard disk with HDD fixing screws on the inner floor of
DVR.
- LRA3040N-NH
- LRA3080N-NH
Cable
- LRA3160N-NH
NOTE
•
Make sure that each of the SATA cables is connected to
the connector housing through its holes. Do not force
to connect the SATA cable and the connector of HDD
mainboard.
•
Do not stack them nor keep them upright.
Cable
Hide quick links:
Advertisement
Table of Contents
