Zte ZXR10 5900E Series Configuration Manual page 48

ZXR10 5900E Series Configuration Guide (Multicast)
Step Command
ZXR10(config-mcast-pim)#
<interface-name>
ZXR10(config-mcast-pim)#
[group-list < access-list-name >]
ZXR10(config-mcast-pim)#
ZXR10(config-mcast-pim)#
access-list-name >
ZXR10(config-mcast-pim)#
ZXR10(config-mcast-pim)#
ZXR10(config-mcast-pim)#
ZXR10(config-mcast-pim)#
<interface-name>
ZXR10(config-mcast-pim)#
ZXR10(config-mcast-pim)#
ZXR10(config-mcast-pim)#
<ip-address>
ZXR10(config-mcast-pim)#
ZXR10(config-mcast-pim)#
ZXR10(config-mcast-pim)#
ZXR10(config-mcast-pim)#
ZXR10(config-mcast-pim)#
ZXR10(config-mcast-pim)#
ZXR10(config-mcast-pim)#
<seconds>
SJ-20150114102049-007|2015-01-15 (R1.0)
no rp-candidate
spt-threshold infinity
no spt-threshold
accept-register <
no accept-register
accept-rp <access-list-name>
no accept-rp
anycast-rp-local
no anycast-rp-local
anycast-rp-peer <ip-address>
no anycast-rp-peer
bsm-unicast
no bsm-unicast
data-filter <access-list-name>
no data-filter
rp-smart
no rp-smart
dr-switchback-delay
4-4
Function
Deletes a candidate RP.
Sets switchover of the SPT.
The threshold is infinity.
Deletes switchover from RPT
to SPT.
Filters the multicast packets
encapsulated in Register
messages.
Disables to filter the packets
encapsulated in Register
messages.
Filters the candidate RP
addresses advertised in the
Bootstrap messages.
Disables to filter the candidate
RP addresses.
Sets anycast-rp local interface.
Deletes anycast-rp local
interface.
Sets anycast-rp peer address.
Deletes anycast-rppeer
address.
Sets unicasting BSR
messages.
Disables to unicast BSR
messages.
Sets PIM source data filter.
Deletes PIM source data filter.
Sets smart RP switch.
Deletes smart RP switch.
Sets the time of recalculating
route after the DR
non-DR while BFD
on the interface.
ZTE Proprietary and Confidential
turns into
is enabled