Display Panel Installation - GE ICRXIDIXNE19LCTA Quick Start Manual

PACSystems RXi 19" Display QSG
GFK-2899B
Grounding
The following guidelines apply for proper grounding:
•
The RXi Display chassis requires a safety ground connection to protective earth. This ground wire shall be at least 16 AWG
(1.31 mm cross section) and should be as short as possible. When mounting the RXi Display, add the ground wire
2
underneath either of the two center screws attaching the RTM assembly to the display panel, and connect to protective
earth.
•
The frame ground connection on the power plug should be a 16 AWG (1.31 mm
length. It is recommended that both ground wires terminate in a star wiring pattern at the same grounding point, and
connect to protective earth.

Display Panel Installation

The RXi Display is installed as a panel mounted operator interface. One person can install the display without the use of any special
tools.
Note: Mount the RXi Display on a flat surface in a UL/NEMA Type 1 enclosure.
The cooling fins on the back of the RXi Display must be vertical. The unit can only be mounted with the front display
Note:
connectors oriented down.
Check the bezel gasket for damage, and replace if necessary.
1.
Swing the eight levers on the back of the RXi Display to their retracted position, held in place by a ball plunger.
2.
From the front of the enclosure, tilt the RXi Display into the enclosure opening and rest its two lower brackets on the
3.
enclosure opening bottom edge.
Push the top of the RXi Display towards the enclosure until the top latch catches the enclosure opening top ledge.
4.
Swing out the eight levers to rest against the enclosure wall.
5.
Using a #2 Phillips screwdriver, tighten the lever screws to 0.79 Nm (7 in-lb) using the tightening order illustrated in the
6.
following figure.
Lever Screw Tightening Order
cross section) wire with shortest possible
2
6