Installing Usb Driver - Microscan MS-Connect 5100 User Manual

Install USB Driver
Step 6 — Install USB Driver
When the MS-Connect 5100 is connected to a 24V power supply and the USB programming
cable is connected to the host computer for the first time, you will be prompted to install
the USB driver.
1. When you see the Found New Hardware Wizard, select Install from Specific
Location.
2. Navigate to the ESP-5100\Device folder.
Note: When ESP is installed, the MS-Connect 5100 USB driver is automatically
placed on the host hard drive along with the other ESP installation files.
Example Location: "C:\Program Files\Microscan\ESP-5100\Device".
3. If the driver is selected, a non-compatibility warning will occur. this warning can be
ignored.
4. After the driver is installed, an extra USB controller is displayed in the hardware
Device Manager.
1-8
MS-Connect 5100 User's Manual