4-1-13 EI SYSTEM DIAGNOSIS
⊙ ⊙ DEALER MODE
The defective function is memorized in the ECU.
Use the special tool's coupler to connect to the dealer mode coupler. (Refer to page 4-1-20)
The memorized malfunction code is displayed on LCD (DISPLAY) panel
Malfunction means that the ECU does not receive signal from the devices.
These affected devices are indicated in the code form.
Mode select switch : 09900-27000
Do not disconnect the ECU lead wire couplers, before checking the malfunction code, or the malfunction
code memory is erased and the malfunction code can not be checked.
Confirm the malfunction code after turn the ignition switch "ON" position or cranking the engine for few
seconds.
MALFUNCTION
"NO"
"YES"
CAUTION
LCD (DISPLAY)
"FI" CHECK LAMP
INDICATION
C
C**code is indicated
from small numeral to
large one.
28
.
INDICATION
"FI" check lamp
goes off.
INDICATION
MODE
-
For each 2 sec.,
code is indicated.